Results 1 to 3 of 3

Thread: zimbra-store fails to install on fc4-x86_64

  1. #1
    Join Date
    Jan 2006
    Posts
    16
    Rep Power
    9

    Default zimbra-store fails to install on fc4-x86_64

    Hi all

    I'm trying to install zimbra on my fc4 x86_64 (dual-arch) box. Most packages install without error. But unfortunately the install script stops after installing zimbra-store. Installing it manually with the commands

    rpm -e zimbra-store
    rpm -ivh packages/zimbra-store-3.0.0_M2_746.FC4-20051116155303.i386.rpm

    gives the error:
    Preparing... ########################################### [100%]
    1:zimbra-store ########################################### [100%]
    cat: /opt/zimbra/zimbramon/zimbramail.cf: Datei oder Verzeichnis nicht gefunden (i.e. file not found)
    could not open session
    could not open session
    Fehler: %post(zimbra-store-3.0.0_M2_746.FC4-20051116155303.i386) scriptlet failed, exit status 1

    Any ideas?

  2. #2
    Join Date
    Sep 2005
    Posts
    2,103
    Rep Power
    14

    Default 64 bit

    The packages aren't compiled for 64 bit architecture, so aren't likely to work.

  3. #3
    Join Date
    Jan 2006
    Posts
    16
    Rep Power
    9

    Default

    Quote Originally Posted by marcmac
    The packages aren't compiled for 64 bit architecture, so aren't likely to work.
    Hmmm... Normally on the dual-arch FC4 box i386 and x86_64 versions can coexist. I have installed mixed libraries on this box, e.g. for running freeNX in a VServer. With Zimbra, I can see that all RPMs install properly, I can even launch the configurator manually.

    I think my problems come from the fact that I have a somewhat "minimum install" in my vserver. To make the configurator work, I had to yum-install the packages sudo, vixie-cron and bind-libs (the installer did not verify that these are here). At the moment the LDAP server fails to load because it tries to bind to all interfaces; in my VServer Setup it may only bind to one IP address/port. I will still try to make zimbra work in my VServer Setup; perhaps I will need to relax the capabilities settings of my VServer.

    Thanks anyway for your help, I will let you know if I succeed to make it work.

    Regards
    --Marcel

Similar Threads

  1. Replies: 26
    Last Post: 04-19-2011, 10:24 AM
  2. Removing hostname from hosts file fixed prob.
    By lemur in forum Installation
    Replies: 10
    Last Post: 06-13-2007, 07:29 PM
  3. 4.5 Upgrade failure
    By brained in forum Installation
    Replies: 9
    Last Post: 03-03-2007, 03:30 PM
  4. zimbra-core missing
    By kinaole in forum Developers
    Replies: 1
    Last Post: 10-02-2006, 12:59 PM
  5. FC3 Install and no zimbra ?
    By aws in forum Installation
    Replies: 10
    Last Post: 10-09-2005, 05:19 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •