I've some question about cluster installation with red had cluster (HA)
I read the "ZCS Cluster install Guide" (network edition 5.0).
I'm using zcs-NETWORK-5.0.2_GA_1976.RHEL4.20080130204528
I have two node nodo1.mydomain.com and nodo2.mydomain.com
my cluster service is: boxha.mydomain.com
add cluster ip to nodo1 :
ip addr add 10.10.10.123 dev eth0
already setup SAN partition
run install.pl --cluster active
insert service name:boxha.mydomain.com
# Mount the SAN Volume:
mount -t ext3 /dev/sdb1 /opt/zimbra-cluster/mountpoints/boxha.mydomain.com
and it's empty....
is it right?
if run again (as describe in doc) install.pl --cluster active and enter the same value
to continue installatione Ihave to run
# Start ZCS Install:
./install.sh -l /tmp/ZCSLicense.xml
there's no other way try to install...
installation ends correctly but the /opt/zimbra-cluster/mountpoints/boxha.mydomain.com is still empty...
where I'm wrong?
Could you help me, plese?