Page 1 of 1

outbound relay requires password POSTFIX not installed

Posted: Wed Jul 11, 2018 10:01 pm
by ercoupeflyer
Mail Relay requires Password. The directions for setting this up use POSTxxx commands, these are not installed with the open source version not sure what to do here. Any help would be very appreciated!

Re: outbound relay requires password POSTFIX not installed

Posted: Thu Jul 12, 2018 5:43 am
by phoenix
ercoupeflyer wrote:Mail Relay requires Password. The directions for setting this up use POSTxxx commands, these are not installed with the open source version not sure what to do here. Any help would be very appreciated!
How about giving us some detail of the exact commands you are using and what output or errors you're seeing plus the location of the article that you're following for these steps. In addition you should always give the version of ZCS that you're using by posting the full output of the following command:

Code: Select all

zmcontrol -v


FWIW, you must be doing something wrong as nobody has complained about this in the past. Are you actually running the commands as the zimbra user?