BES Express - stuck after SRP ID and Auth KEY
Ive been following the ZCB Guide relatively close, but its rather vague when you encounter something outside the norm.
Heres where I am stuck at:
Installing CDO, Outlook, and BES
Use the appropriate software documentation to install the following:
1. Install Microsoft Windows Server 2003 and the latest service packs.
2. Install Microsoft Exchange Server MAPI/CDO 1.2.1 and the latest service
3. Install BlackBerry Enterprise Server for Microsoft Exchange 4.1 or
BlackBerry Professional Software for Microsoft Exchange 4.1
Note: During the BES installation, after you enter your SRP information,
you may be prompted to enter profile creation information in a Microsoft
Exchange Server dialog. Press OK to skip this step. Ignore any
subsequent BES profile errors, such as an Invalid properties error.
Note: During the BES installation ignore warnings such as Exchange
Server is not detected errors or Could not verify the Microsoft Exchange
So I ve started installing BES express Im at the SRP ID and Auth KEY, I hit next - I get "Microsoft Exchange Server" So per the guide, listed above, I click ok to skip.
"BESProfile Error - The (Blackberry Server) profile is invalid due to missing or invalid property" Yippie, the guide warned me so continue following the guide. Click Ok
Then I get "Blackberry CAL and SRP Information: The MAPI subsystem cannot be correclt initialized and used. Please make sure MAPI is installed and configured properly".
So I installed MAPI/CDO not a whole lot there than running the msi and clicking finish. So not sure on the configuration part. Back to the issue, so I click ok to the above error. It goes back to the BES Installation - Blackberry CAL and SRP Information Page.
Not sure what to do next.
BES connector for BESx 5.x.x
When will be available the Bes connector for BES Express 5.x.x?